CP-CANFD

•  Adds one or two high speed CAN FD interfaces via a USB connection
• 10-pin terminal block connector for connecting to CAN bus interface
• Meets the requirements of the ISO 11898-2:2016 high speed CAN specification
• Complies to CAN specifications ISO 11898-1 for CAN and CAN FD
• CAN FD support both ISO-11898-1:2015 and Bosch M_CAN revision 3.2.1.1
• Supports CAN FD data rate up to 8 Mbps
• Supports CAN bus speed up to 1 Mbps
• Non-standard baud rates supported
• Supports CAN bus message filter configuration
• Provides +5V DC output at 100mA through pin-4 (port 1) and pin-9 (port 2) of terminal block
• Supports CAN 2.0A and CAN 2.0B protocols
• Supported CAN modes 
  - Normal mode: normal operation on CAN bus   
  - Listen mode: passive receiving of CAN frames   
  - Loopback mode: transmitter also receives sent frames (for testing purposes) 
• Built-in 120 Ohm termination resistors for CAN bus termination with a selectable jumper
• Firmware upgradable for future firmware revisions
• Galvanic isolation between PC and CAN bus connection up to 5700 Vrms (available only on CP-CANFD-1P-ISO and CP-CANFD-2P-ISO Adapter)
• CAN/CAN FD interface can be controlled over COM port using simple ASCII commands 

Downloads 

CP-CANFD Datasheets 

CP-CANFD Programming Guide 

CP-CANFD CDC Driver Installer (Installer for the CP CANFD Drivers*)

CP-CANFD Update (Firmware update utility for CP CANFD* )

CP-CANFD Utility (Windows application software for testing and transmitting/receiving CAN FD frames*)

CP-CANFD Busmaster Patch (Open-source software tool for simulating, analysing and testing data bus systems such as CAN*)